Understanding the difference between IC rated light fixtures vs non - IC rated fixtures is important for reducing fire hazards in your home and office. Proper insulation is the only way to fix large amount of thermal leakage. IC rated cans are intended for direct contact with insulation.
Ten Mat covers are one way to deal with recessed lights. They are in the ceiling of my 2nd floor office, with the attic above.
If you want to install non - IC rated fixtures in an insulated ceiling, you can use an airtight cover to keep the insulation from touching the can.
What Is IC - Rating for Recessed Lights ?
Two types of recessed lighting are available: IC rated and non - IC rated. IC - rated recessed lighting has extra protection and superior heat . IC stands for insulation contact and refers to whether or not it is safe for insulation to touch the recessed light fixture. These housings are typically rated up to 1watts.
IC rated remodel housings are used in existing ceilings where insulation will be present and in contact with the fixture. I'd like to cover the cans with air tight, fire rated boxes. However, these also require that there be no contact . The plan is to blow cellulose insulation over the boxed fixtures.
My concern is about lamp-generated heat being trapped in these air tight, insulated boxes. CHOOSE THE SMART CHOICE FOR ATTIC NON - IC RATED LIGHT FIXTURES. Light Cover to your list of hard working insulation accessories. Choosing the right recessed lighting fixture depends on whether you have insulation installed in your ceilings.
Insulated cans can also you money on your ene. LBC Lighting - Introduction to Recessed Lighting IC vs . Retrofits or new installs, CanCoverIt is the easiest, most efficient way to insulate recessed lighting and other protrusions. With two series to choose from.
Universal series is designed to work with Non - IC rated fixtures and IC rated and features patented passive venting technology. IC rated lights are usually rated for no more than 1watts, often watts, whereas non - IC rated light housings are often rated for . Inspectors see insulation and they expect to see the silver cans, which is what an IC can would . I have ten non - ic lights that protrude up into the attic would it be any better to use the foil faced insulation board to make the boxes instead of the plain .
No comments:
Post a Comment
Note: only a member of this blog may post a comment.