Dimmer switch l1 l2

Dimmers look slightly different to standard switches being much more chunky. The Lis the switched live going out to the light. They will be marked so you can tell which is which. Two way switch (UK light switch ). Lis off when Lis on and vice versa depending on the switch .

C and Lterminals of the dimmerswitch.

The colour of the wires may vary but you must know where each should go on your new dimmer switch.

Brown (or red) wire must go into C (Common). Grey wire must go into L(if black, it can go into Lor L). Expert electrical DIY tips from VideoJug and Aspect Maintenance. Dimmer switches are popular because the light in the room can be dimmed to make. There are two wiring options for this: More advanced dimmer . L= C L= LL= LIf the new switches are metal, you must connect the switch to earth (Terminal on the plate, you connect it to the existing earth wires) Also are the new dimmers rated enough to cope with the lamps?

The rating must be more than the total of the lamps. My old one is marked L, Land C - my new one is marked Loa Slave and Live. COM on the first switch connects to COM on the second switch, Lto L, and Lto L2.

NOTE: IF YOU ARE IN ANY DOUBT ON HOW TO. Switch OFF the mains supply and remove the appropriate fuse or switch off the appropriate circuit breaker before commencing installation. Ensure that no one else has access that would enable the supply.

The wires fitted into the other two terminals of the old switch should be fitted either way round into terminals Land Lof the dimmerswitch. The Land Coms just need to have the same wiring on the new dimmer switch. Note: Our dimmer switches are not suitable for use with fluorescent loads, including. Scolmore International Lt Scolmore Park, Landsberg, Lichfield Road Ind.

Inceptor Max - Electrical Parameters. Specification is subject to change without notice. The wiring is very simple as you simply follow the wiring of the switch that you are replacing.

This dimmer has terminal for L, Land common which is identified by the sine wave symbol ~. Just to check would the single wire on either side be connected to the com on my original light switches and the other two wires be connected to the Land L? If this is so which inputs do you think they would connect to on the lightwave dimmer sockets?