Lte rf parameters

The same types of parameters are measured for LTE as for other cellular technologies. Beyond the essential protocol log, which provides visibility of the fundamental interaction with the network, the initial focus is on RF coverage and quality. In LTE systems, cells are grouped. They are searched based on the primary and secondary synchronization sequences.

The following figure shows the schematic diagram.

In the LTE system, the handover procedure is controlled by the network (eNodeB).

Analysis of LTE UE RF parameters for 3GPP specification.

Abstract: The 3GPP Specification TS 36. Beyond the essen- tial protocol log, which provides visibility of the fundamental interaction with the network, the initial focus is on RF coverage and quality. This workshop provides insights into the symptoms and possible causes of field performance issues in LTE radio networks using UE logs.

RF measurements related to coverage and interference are discussed to analyze coverage holes and overlapping regions. Students analyze LTE signaling messages through UE logs . CQI depends on the RF conditions. LTE DRIVE TEST PARAMETERS RSRP :- Reference signal receive power.

RSSI = Received Signal Strength Indicator N: number of RBs across the RSSI is measured and depends on the BW. Significance : RSRP is the most basic of the UE physical layer . G LTE Drive Test (DT) parameters course by TELCOMA Training. LTE basics:- specification overview.

It is worth summarizing the key parameters of the 3G LTE specification. Sharawi published the chapter: RF Planning and Optimization for LTE Networks in the book: RF Planning and Optimization of LTE Networks. RF network performance and coverage. Model tuning according to field measurements is discussed to . Transmission bandwidth configuration.

Radio Parameters of LTE -Advanced. Operating bans for LTE - Advanced. Deployment scenarios for initial study. Feasibility studies on radio aspects.

Huawei Confidential Page Contents Network and RF Optimization Processes LTE RF . TR and the updates required in test specification TS 36.